Step 1: Surface Preparation

1. Clean the Surface: Thoroughly clean the surface to remove any dust, dirt, grease, or loose particles. Use a broom, vacuum, or damp cloth as needed to ensure a pristine base.
2. Dry and Level: Ensure the surface is completely dry and level. Address any cracks, holes, or uneven areas by filling or smoothing them out to create a uniform substrate.
3. Prime if Necessary: If the surface is highly porous or challenging to bond, consider applying a suitable primer to enhance adhesion.

Step 2: Mixing TDMX with Cement and Sand

1. Measure Ingredients:
   • 1 packet of TDMX.
   • 70 kg of Quartz or Silica Sand.
   • 30 kg of Cement (OPC or PPC).
2. Simultaneous Mixing: Combine the TDMX, sand, and cement all at once. Mix thoroughly to ensure even distribution.

Step 3: Adding Water

1. Take the Necessary Quantity: After mixing the dry ingredients, take the required amount of the mixture.
2. Add Water: Gradually add water to the measured quantity while mixing. Use a mechanical mixer or mix by hand until a smooth, lump-free paste is achieved.
3. Consistency Check: Ensure the mixture has a paste-like consistency that can be easily applied with a trowel.

Step 4: Application

1. Apply Adhesive: Using a notched trowel, spread the adhesive mixture evenly over the prepared surface.
2. Tile Placement: Firmly press the tiles into the adhesive, making any necessary adjustments within the open time.

Step 5: Curing

1. Curing Time: Allow the adhesive to cure for about 24 hours before subjecting the tiles to traffic or applying grout.
2. Final Check: Immediately clean off any excess adhesive from the tile surfaces to avoid staining.

This approach ensures an efficient mixing process and consistent application for strong, durable tile adhesion.